Berner 30976, Instructions For Use Manual

Page: 8 / 28

7
BATTERY TEST
1 Connect the black clip to the neg. pole and the red clip to the positive pole
3 The following message will be displayed on screen:
4
After a few seconds, the battery voltage without load
will be displayed on screen.
5 Press
6 Select test: Battery
7 Press
8
Select the battery temperature
(Higher than 0°C or Lower than 0°C)
9 Press
10
Select the test standard (Printed on the battery): EN,
SAE, DIN, IEC. For JIS standard, select SAE.
11 Press
12
Select the battery start-up current.
For JIS standard, see the table shown on Page 1 or see
the back of the tester.
13 Press
14 Select battery type:
Standard SLI UNSEALED liquid acid battery
VRLA GEL AGM Battery with gelled electrolite
SLA SEALED liquid acid battery
15 Press
16
After a few seconds, the result will be displayed on
screen.
Power at startup can exceed 100%
Battery
Voltage Power at startup shown as a
% of nominal current
Battery status:
- GOOD
- REPLACE
- GOOD RECHARGE
- RECHARGE – Recharge the battery and repeat the test