Bergen Intrepid Magnum Tazer, Manual, Page: 80 / 88

Tighten the nut sufficiently to prevent the bolt from turning and
thread the ball link onto the stud.
Assemble the other end the same way, then glue ONE end on to the
carbon fiber rod.
Snap this end onto the tail servo wheel ball, making sure the ball is
pointed straight down with power on. Snap the loose push rod end onto
the medium ball on the tail pitch bellcrank. Mark the point on the
carbon fiber rod where it needs cutting so it fits into the push rod end
assy. When measuring for this, make sure the tail pitch bell crank is at
90 degrees and the tail pitch slider is centered on the output shaft.
Glue the end onto the cut carbon fiber rod and let dry overnight.