Bergen Intrepid Magnum Tazer, Manual, Page: 41 / 88

Set the bearing tension by holding the jamnut and tightening or
loosening the bolt, then tighten the jamnut against the Popsicle stick.
The “X” arm should spin freely with no slop.
Install the aileron servo into the Aileron servo mount. Install the
rubber grommets and eyelets that come with the servo from the bottom
side. This is the only servo to use these eyelets.
Snap the plastic servo mount tabs into the aileron servo mount, from
the bottom. Slide the servo into the mount so that the “ears” fit into
the cutout area of the mount. Also note the servo output shaft is
forward, or towards the curved front of the servo mount.