Operation and Menu Structure
NewSonic SonoDur-R
Issue 105 06/2020
Page 51
7.12
SonoDur Data Processing
SonoDur-R provides the ability to save, recall and transfer measurement data to external computers.
7.12.1
Storing Data
Measurement data can be saved with a designation and recalled at any time via the device menu.
Furthermore, SonoDur-R asks when exiting the measurement series via the
Exit
button, whether the
measurement data should be stored or not. This also applies in the case where the test procedure is
to be changed (penetration time, new adjustment number). If the question is answered with "Yes",
the device menu for storing measurement data will be invoked. SonoDur suggests a file designation
and increments it by one each time a new series of measurements is started. An error message will
be issued if the record is saved using an already existing designation (
) in this case chose
another name.
Figure 7.112
Figure 7.113
i
NOTE!
The "Data" area is predefined as data folder. A new storage location cannot be created in the test
program; such task must be performed by using the file manager of the operating system.
7.12.2
Opening File (Load File)
If "Load file" is invoked in the "Device menu", any stored measurement series can again be displayed.
The accessible program area is restricted to the information area, i.e., the data can only be viewed
bis
). The current measurement series must be closed before a file is
opened that can be saved.
Figure 7.110
Figure 7.111
