9
Automatic Pot Stirrer Use instructions
EN
BATTERY CHARGE:
To charge the battery, insert the charger pin into the appropriate slot on the back of the motor housing. The inlet
is protected by a small rubber square, pull the square down and insert the charger pin.
A red light will come on to indicate that the product is charging.
When the product is fully charged, the light will turn green.
The charging time is approximately 4 hours.
When fully charged the product will work for about 2 hours. The operating time will depend on the consistency
of the food to be mixed.
ASSEMBLY AND USE OF THE PRODUCT: Fig.B
Place the motor housing on the central part of the brackets and turn it anticlockwise until it is completely locked.
To be assembled correctly, the motor housing must be perfectly in line with the brackets.
Insert the axle into the stirrer blades and then into the central part of the brackets.
Place the product so assembled on the pan and adjust it to the diameter of the pan (can be suitable to pots with a
diameter from 15 up to 25 cm). At this point, press on the pliers placed under the brackets to fix the product to the
pan. Instead, being the axel movable will automatically adapt to the height of the used pot (from 10 up to 20 cm).
At this point press the ON / OFF button to activate the stirrer.
The product will start to mix at the speed set during the last use.
To adjust the speed, use the button with the arrows placed next to the power button.
If during the operation the red light accompanied by an acoustic signal will lights up, it means that the battery is
running low. Turn off the product and charge it again.
To switch off the product, press the ON / OFF button again.
To remove the product from the pot, press on the pliers placed under the brackets and lift it, paying attention to
the central axel that is movable and may fall. Take care that the axle has remained in contact with the food, so it
will be very hot, so it is recommended to use the proper precautions.
CLEANING AND MAINTANANCE:
Clean the motor body with a soft cloth slightly moistened with water. Do not immerse in water or other liquids.
Do not wash in the dishwasher.
The brackets, the stirrer blades and the axle (after having disconnected it from the motor body) can be washed
in warm water and neutral liquid soap or in the upper basket of the dishwasher paying attention to set a tempe-
rature not higher than 60 ° C.
TECHNICAL DATA:
Power: 4,2VDC - 5W LITHIUM BATTERY
Power supply: AC 110-240V ~ 50/60Hz- 0,3A
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
Summary of Contents for BP.961
Page 34: ...beper com YOU MIGHT ALSO LIKE ...
Page 35: ...beper com ...