16
firing process interrupted after power breakdown
After re establishing power supply the firing process
has been interrupted due to e.g. kiln temperature has
dropped too much. If there is a digit shown after the
comma it gives further informations about the cause
(e.g. B3.4 = temperature dropped too much).
If this error message comes up right after turning on
the controller by the mains switch you can disregard.
It just means that the controller has been turned off
last time when the firing had not been totally completed.
Simply continue working by entering a programme.
internal problem
Technical assistance required (C1 signal acquisition
broken, C2 signal acqusition not within precision
limits, C3 systembus communication error, C4
systembus configuration setup mismatch).
hardware error
Technical assistance required (D1 processor fault, D2
RAM error, D3 bus error, D4 configuration memory
error, D5 calibration data invalid).
Error B3
Error C1, C2
C3, C4
Error D1, D2
D3, D4, D5
