The TC507 is the first controller on the market which
provides you with the very handy feature of entering a
ramp as degrees centrigrade per hour or as time to a
temperature. In the current example you can enter
segment 1 as 2 hours instead of 250°C/h. To do this,
press key „time“ instead of „rmp“ and enter the time
of 2.00 hours.
To double check you can press the key „rmp“ and you
will find the value of „250°C/h“ as you expect. This
calculation works in either direction.
When entering an uncontrolled ramp (SKIP) in time
mode you have to enter „0“ (see our example).
Depending on programme length and some other
parameters the TC507 is capable of saving up to 99
firing curves as programmes. Once a firing curve has
been saved as a programme it can be called up easily
to be modified, saved again or simply used by starting
the firing.
To save a firing curve that has been entered before as
e.g. programme number 35 proceed with the following
steps: Press key (8). The display (6) is blinking asking
you to enter the programme number (the decimal
point means that a programme is to be saved).
Now enter programme number 35 using the digit
keys. Display (6) reads the programme number. The
programme number is only shown if the current firing
curve is identical with the saved programme (which is
always the case after loading or saving a programme).
Therefore if you change any value of the current firing
curve the display (6) becomes blank until you save
this programme.
7
o
dwell
time
°
C/h
h.min
°
C
°
F/h
°
F
k
prog#
seg#
value
rmp
tmp
Programmes
o
dwell
time
blinking
°
C/h
h.min
°
C
°
F/h
°
F
k
prog#
seg#
value
rmp
tmp
o
dwell
time
°
C/h
h.min
°
C
°
F/h
°
F
k
prog#
seg#
value
rmp
tmp
memo
3
end
5
Note
The progamme number
must always
be entered as a 2
digit number. Example: Enter „05“ for programme no. 5
Saving Programmes
