Maintenance
29
7.3.1 Display Interface Module Firmware Installation Procedure
The following steps will need to be followed to complete the Display Interface
Module firmware upgrade:
Ensure that the Module’s configuration is saved using the 3500 Rack
Configuration software.
Refer to Section 1.2 (Handling and Storing Considerations) before handling
the monitor or the upgrade firmware IC.
Remove the monitor from the 3500 rack.
Remove the Top Shield from the monitor.
Remove the original firmware IC from the monitor PWA.
Install the upgrade firmware IC into the socket on the monitor PWA.
Replace the monitor Top Shield.
Replace the monitor into the 3500 system.
Reconfigure the monitor using the 3500 Rack Configuration software.
Detailed instructions for some of the steps listed above are provided on the
following pages. Please review completely before proceeding.
7.3.1.1
Top Shield Removal
1) Top
Shield.
2) Standoff.
3) Screwdriver.
Step 1. Place the large flathead screwdriver under the top shield and on the
ridge of the rear standoffs and lift upward on the screwdriver to pop the cover
loose from the rear standoffs.
Summary of Contents for 3500/93
Page 6: ...3500 93 SYSTEM DISPLAY vi...
