18
GSM/GPRS Alarm Communnicator
INTRODUCTION
The BGSM-G is a backup wireless communicator that sends alarm system information to a System III or System II receiver, or a PC with
WinBCS (2.0 or higher), through a GSM/GPRS wireless network. The BGSM-G is available in two models that are different for the
operating frequency only: BGSM-G/AM = 850/1900 MHz; BGSM-G/EU = 900/1800 MHz.
This manual provides programming and operating instructions for both the BGSM-G GSM/GPRS alarm communicators. Information
relating to a specific model will be denoted by the applicable model number within the text. The term "Device" is used to describe
functionality that is applicable to both models.
,
,
,
,
,
This Device is fixed and shall be installed by Service Persons only (service person is defined as a person having the
appropriate technical training and experience necessary to be aware of hazards to which that person may be exposed
in performing a task and of measures to minimize the risks to that person or other persons). It shall be installed and
used within an environment that provides the pollution degree max 2, over voltages category II, in non-hazardous,
indoor locations only. This manual shall be used with the Installation Manual of the alarm control panel. All instruc-
tions specified within that manual must be observed.
Features
Technical Specifications
The input voltage to this Device can be drawn from the Control Panel or provided by the
ADP1512
power supply (optional).
Simulates land line
Switches automatically to GSM Network in the event land line
trouble (line down)
Manages and signals Incoming/Outgoing calls
GSM signal indicator
4 programmable OC Outputs
Houses 12 V / 1.2 Ah battery (optional)
Tamper protection contact
Land line overvoltage protection
Dual-Band
4 Input Lines
SMS Alerts
Supports Contact ID communication format from a connected
control panel for communication over the GPRS network
GPRS/Internet communication with Sur-Gard System III / II
13 SMS Messages (2 messages per Input Line and 5 Status
messages)
8 phone numbers (max. 20 digits) programmable for SMS Dialer
4 phone numbers programmable for Contact ID Dialer
Up to 95 phone numbers (max. 20 digits) can be programmed
to manage remote control of the OC Outputs
Remote control of the OC Outputs via SMS and/or over-the-
phone after caller recognition
Pay-As-You-Go Balance message (for pre-paid SIM Cards)
(#
(. #
1
/01 0
/
/
!$%" !#2(#$1%
+ /
&
$ #
'&
'3! !( !!##2(4#%$#") $
#$&
#! /
&*+
*+
$ "
1&$
% 2 !
01&'(
,%
% 2! &
'(
#
&#'./'#'.5
)
0'0&&&1'0101 %
3#101 /
*"11
Summary of Contents for BGSM-G
