Operation
34
Shutting down the projector
1.
Press
POWER
or
OFF
and a confirmation message will display prompting
you.
If you don't respond in a few seconds, the message will disappear.
2.
Press
POWER
or
OFF
a second time. The
POWER indicator light
flashes orange, the projection lamp shuts down, and the fans will continue to run for
approximately 90 seconds to cool down the projector.
To protect the lamp, the projector will not respond to any commands during the cooling process.
To shorten the cooling time, you can also activate the Quick cooling function. See
"Quick Cooling" on page 41
for details.
3.
The
POWER indicator light
is a steady orange
and fans stop. Disconnect the power cord from the
power outlet.
•
If the projector is not properly shut down, to protect the lamp,
when you attempt to re-start the projector, the fans will run for a
few minutes to cool down. Press
POWER
or
ON
again
to start the projector after the fans stop and the
POWER
indicator light
turns orange.
•
Lamp life results will vary depending on environmental conditions
and usage.
Direct power off
The AC power cord can be pulled out right after the projector is turned off. To protect
the lamp, wait about 10 minutes before re-starting the projector. (When you attempt to
re-start the projector, the fans may run for a few minutes to cool down. In such cases,
press
POWER
or
ON
again to start the projector after the fans stop and the
POWER indicator light
turns orange.
