BenQ Mainstream MP611, Product Service Manual

Page: 46 / 168

46
Note: If BenQ defect undefined failure, and it judged that is reduce the
merchandisebility, BenQ CM Inform this defect. After that parties make
communication and decide how to solve.
5.3.6. EXPRESSION OF DEFECTIVES
Number of defects
Percent of defects = ------------------------------------------ X 100%
Number of products inspected
5.3.7. INSPECTION STANDARD
Unless otherwise specified, the inspection standard will be defined by MIL-STD-105E,
NORMAL INSPECTION LEVEL Ⅱ , SINGLE SAMPLING PLAN. Level Ⅱ is in use all the
time, inspection levels are normal, reduce and tighten.
5.3.7.1 Acceptance Quality Level
5.3.7.1.1. Critical Defect:
When a critical defect is found, this must be reported immediately upon
detection, the lot or batch shall be rejected and further shipments shall be held up
pending instructions from the responsible person in relevant department.
5.3.7.1.2 under normal sampling
Critical Defective : 0% AQL
Major Defective : 0.65% AQL
Minor Defective : 2.5% AQL
5.3.7.1.3 under special sampling
Critical Defective : 0% AQL
Major Defective : 1.0% AQL
Minor Defective : 4.0% AQL
5.3.8. GENERAL RULES
1) The inspection must be carried out by trained inspectors who have good knowledge
about the product.
2) The inspection must be based upon the documents concerning the completely
assembled and packed product.
3) When more defects appear with the same unit only the most serious defect has to be
taken into account.
4) Defects found in accessory packed with the product such as Cable, Connector,