43
Selecting an input source
The projector can be connected to multiple equipment at the same time. However, it only displays one full screen at a time. When starting up, the
projector automatically searches for the available signals.
To select the video source:
1. Press
on the projector or your remote control to display the source selection bar.
2. Press / until your desired signal is selected and press
OK
.
Once detected, the selected source information displays on the screen for seconds. If there are multiple pieces of equipment connected to the
projector, repeat steps 1-2 to search for another signal.
The native display resolution of this projector is in a 16:9 aspect ratio. For best display picture results, you should select and use an input signal which outputs at this
resolution. Any other resolutions will be scaled by the projector depending upon the Aspect Ratio setting, which may cause some image distortion or loss of picture clarity.
See
Aspect Ratio on page 62
for details.
Summary of Contents for GSI Outdoor Leisure Series
