![background image](http://html.mh-extra.com/html/benq/gh200-series/gh200-series_user-manual_2733716035.webp)
35
1.
In the REC mode, press [ ] ( ) once.
2.
Use [ ] and [ ] to select the flash setting
you want and then press [SET].
•
If there are no indicators on the monitor
screen, you can cycle through the flash modes
by pressing [ ] (
). You can turn display
information on or off by pressing [ ] (DISP).
3.
Press the shutter button to shoot.
Red-eye Reduction
Using the flash to shoot at night or in a dimly lit room can cause red spots inside the eyes of
people who are in the image. This is caused when the light from the flash reflects off of the
retina of the eye. When red-eye reduction is selected as the flash mode, the camera fires a
pre-flash to cause the irises in the eyes of any people in the image to close, which reduces
the chance of red eye.
Note the following important points when using red-eye reduction.
•
Red-eye reduction does not work unless the people in the image are looking directly at
the camera (flash).
•
Red-eye reduction may not work very well if the subjects are located far away from the
camera.
Using Flash (Flash)
Auto Flash
Flash fires automatically in accordance with exposure (amount
of light and brightness) conditions.
Forced Off
Flash does not fire.
Forced On
Flash always fires. This setting can be used to brighten a subject
that normally comes out dark due to daylight or backlight
(daylight synchro flash).
Red Eye
Reduction
Flash fires automatically. This type of flash can be used to
reduce the chance of redness in the subject’s eyes.
Flash
[
] (
)
Back lamp
Flashes orange while the flash is charging to
indicate that image recording is disabled.
• You will not be able to take another flash
snapshot until the lamp stops flashing
orange, which indicates that charging is
complete.
indicates the flash will fire.
GH200_205 UM EN - New Fonts.book Page 35 Tuesday, February 14, 2012 5:32 PM