Section 1: Quick Start Guide
6
En
gli
sh
Test the remote control
7. Initialise the display
When first turned on (and until tuned), the "First Turn On" menu will display:
The display uses the selections you make in this menu to determine which menu language to
display and which TV station programs to search for and tune appropriate to the region you
selected. This process need only ever be done once.
1. You can use the
left,
right,
up and
down buttons on the remote control or the
display to navigate through the menu, and use the OK button on the remote control or the
Input button on the display to make each selection.
2. When you select a ‘Language’, the ‘Country’ and TV ‘Standard’ items will change
automatically to suit. You can select from English, Français, Nederlands, Deutsch, Italiano
and Español.
•
Once you’ve selected a ‘Language’, if your country is not displayed in the ‘Country’ item, you
can select one from UK, France, Netherlands, Germany, Italy, Spain, Austria, Belgium,
Luxemburg, Switzerland, Portugal, or Others.
•
If ‘Others’ is selected as the ‘Country’, you will also need to select the TV broadcast standard
suitable for your region from BG, DK, I or L.
3. After you’ve chosen your ‘Language’, ‘Country’ and TV ‘Standard’, select the ‘Auto
Installation’ menu item and then press the OK button on the remote control. After a short
pause, the display will start searching for available programs and tune, sort and store them
for you. This may take several minutes, depending on the available TV programs in your
local reception area. Please allow the display to complete this tuning process.
Press the Power button on the remote control. The display should turn
on, and the power indicator change to green. If so, progress to the next
step (
7. Initialise the display
) below.
If the display does not turn on, first check that the power is available
(the power indicator will be lit red).
If so, try pressing the power button on the right of the top edge of the
display. If the display turns on by this method, the problem lies with the
remote control.
Secondly, check that the remote control batteries are properly installed.
If need be, replace the batteries with new ones or known good ones.
See the troubleshooting section at the rear of the User’s Manual for
further assistance.
To turn off the display, press the Power button on the top of the display,
or the Power button on the remote control again, and the display will
return to standby mode (the power indicator will turn red.)
DV3251-En-QuickStartGuide.fm Page 6 Tuesday, December 13, 2005 2:03 PM
