27
11/ 2019
BENNING CM 10–PV
In order to prevent any danger, always measure a present volt-
age first without low-pass filter (without high-frequency sup-
pression) to detect a dangerous voltage.
Before starting the current clamp multimeter, always check the
device as well as all measuring leads for damages.
If it can be assumed that safe operation is no longer possible, switch the device
off immediately and secure it against unintended operation.
Safe operation can be assumed to be no longer possible, if
- the device or the measuring leads exhibit visible damages,
- the device no longer works,
- the device has been stored under unfavourable conditions for a longer period
of time,
- the device was exposed to extraordinary stress during transport, or
- if the device or the measuring leads are exposed to moisture.
In order to prevent danger
- do not touch the bare contact tips of the measuring leads,
- plug the measuring leads into the correspondingly marked
measuring sockets of the multimeter and check them for
tight fit.
Maintenance:
Do not open the multimeter, because it contains no components
which can be repaired by the user. Repair and service must be
carried out by qualified personnel only!
Cleaning:
Regularly wipe the housing by means of a dry cloth and clean-
ing agent. Do not use any polishing agents or solvents!
3. Scope of delivery
The scope of delivery of the BENNING CM 10-PV comprises:
3.1 One BENNING CM 10-PV
3.2 Two safety measuring lead, red/ black (L = 1.4 m) (part no. 044145)
3.3 Two safety crocodile clips, red/ black, 4 mm plug-in technology
3.4 One BENNING TA PV measuring adapter (item no. 10217846)
3.5 One compact protection carrying case
3.6 One wire temperature sensor, type K
3.7 Two 1.5 V batteries (type AA/ IEC LR6) for initial assembly is integrated
into the device
3.8 One operating manual
Note on optional accessory:
- Flexible AC current transformer BENNING CFlex 1 (part no. 044068)
Alternating current ranges: 30 A/ 300A/ 3000 A
- Temperature probe (K-type) made of V4A tube
application:
insertion probe for soft-plastic materials, liquids, gas
and air
measuring range:
- 196 °C up to 800 °C
dimensions:
length = 210 mm, tube length = 120 mm, tube diameter
= 3 mm, V4A (P.no. 044121)
Parts subject to wear:
- The BENNING CM 10-PV is supplied by means of two integrated 1.5 V bat-
teries (AA/ IEC LR6).
- With the protective caps being attached, the safety measuring leads men-
tioned above (tested accessories, item no. 044145) comply with CAT III
1000 V/CAT IV 600 V and are approved for a current of 10 A.
- The BENNING TA PV measuring adapter mentioned above (tested acces-
sories, item no. 10217846) complies with CAT II 1000 V AC/1500 V DC, and
with the protective caps being attached it complies to CAT III 1000 V/CAT IV
600 V.
