STATUS REQUEST OF RECEIVER OUTPUTS:
This command permits to know the status of outputs, in other words whether they are activated or not
(preset outputs in impulsive mode will always how their OFF status).
recstatus 123456
where:
recstatus
command string
123456
access password
REPLY:
As a reply a string containing SMS activating messages regarding channels and showing their ON/OFF
status is sent
Note: To preset the channel operating modes (monostable/bistable/timed) see instructions of the RR 4
receiver.
POSSIBLE ERROR REPLIES:
The system sends the following error messages, through SMS.
“COMMAND MESSAGE NOT SET”
Check the syntax of the command string
“NO PASSWORD FOUND”
Check the syntax of the password configuration command
“COMMAND EXECUTION ERROR”
The command was not executed
“SYNTAX COMMAND ERROR”
The command is correct, but the parameter syntax is incorrect
“PASSWORD ERROR”
Check password
“ERROR UNKNOWN”
General error
“ERROR, MEMORY FULL”
Receiving memory is full. No other remote control number can be memorised
“COMMAND UNKNOWN”
The control signal is not recognized
“PHONE NUMBER NOT PRESENT”
The telephone number to be cancelled is not stored in memory
“ERROR INTERNATIONAL DIALING CODE”
Check the syntax of the memorised numbe
“UNAVAILABLE TELEPHONE NUMBER”
The command was sent by a number which is memorised, but not enabled
10
11
