After 60 sec wait, the receiver exits the programming mode and the display switches off.
Each single function, which is available in the control unit, is described in the following tables
PARAMETERS
MENU
FUNCTION
MCH1
The operating mode of channel 1 is preset.
The descriptions of the single submenus are shown hereunder:
IMp
Monostable. The relay activates for 1 sec when the corresponding key is pressed;
then the relay returns to its original status.
TG
Bistable. When the associated key in the transmitter is pressed, the relay activates.
It remains in its new status until the key is pressed again.
time
Timed. The relay activation time can be preset within a range of 1 to 600 seconds
(10 min).
Select the desired activation time between 1 and 600 seconds, then press OK to
store the val ue into memory.
MCH2
Same operating modes preset for MCH1.
MCH3
Same operating modes preset for MCH1.
MCH4
Same operating modes preset for MCH1.
RADIO
MENU
FUNCTION
Add
Menu to type in the transmitter codes in memory.
The submenus are described hereunder:
CH1
The key is associated to channel 1. Press, within 5 sec, the transmitter key which is
to be associated to channel 1.
CH2
The key is associated to channel 2. Press, within 5 sec, the transmitter key which is
to be associated to channel 2.
CH3
The key is associated to channel 3. Press, within 5 sec, the transmitter key which is
to be associated to channel 3.
CH4
The key is associated to channel 4. Press, within 5 sec, the transmitter key which is
to be associated to channel 4.
DEL
Menu to erase previously typed in transmitter codes from memory.
The single submenus are described hereunder:
code
The receiver is in a waiting mode, waiting for a memorized transmitter key to be
pressed.
The transmitter is erased from the receiver memory.
indh
Remove a transmitter code for which the position in memory is know, see function
FIND>>Code.
res
The receiver memory is completely erased. All transmitter codes and relevant associations
and channel parameters are cancelled. A confirmation of the operation is being asked.
find
Search Menu for transmitter codes stored in memory.
The single submenus are described hereunder:
Code
The receiver is waiting for a code. Press any key on the transmitter; if this is stored
its position in memory is displayed.
N Tx
The number of transmitter codes stored in the receiver memory is displayed.
14
15
