14
8. After vehicle is raised to the desired height, lower the
lift onto the nearest safety lock.
ALWAYS INSURE ALL
SAFETY LOCKS ARE ENGAGED
before entering work
area. (See Fig. 7.2)
To Lower Jack:
1. Before lowering vehicle, be sure all personnel are
clear of the lift and surrounding area. Pay careful
attention to overhead clearances. Insure all tools and
equipment have been cleared from under the Jack.
2. Raise the Jack off of the Safety Locks by pressing
the push button on the Power Unit. Make sure you raise
the Jack to allow adequate clearance for the Locks to
clear.
3. Flip the Safety Handle up to raise the Safety off the
Safety Lock Pin. (See Fig. 7.3)
4. Push the Lowering side of the Pedal on the Air
Hydraulic Pump until the lift has descended completely.
When lowering the lift
PAY CAREFUL ATTENTION
that
all personnel and objects are kept clear.
ALWAYS
keep
a visual line of site on the lift
AT ALL TIME
S.
DANGER!
VISUALLY CONFIRM THAT ALL PRIMARY
SAFETY LOCKS ARE ENGAGED BEFORE
ENTERING WORK AREA.
Suspension components used on this Jack are
intended to raise and lower Jack only and are not
meant to be load holding devices. Remain
clear of elevated Jack unless visual confirmation
is made that all primary Safety Locks are fully
engaged and the lift is LOWERED onto the
Safety Locks, Refer to installation /operation
manual for proper Safety Lock procedures
and /or further instruction.
Fig. 7.2
Fig. 7.3
Summary of Contents for RJ-12
Page 2: ...2 This page intentionally left blank...
Page 10: ...10 Fig 3 2...
Page 16: ...16...
Page 20: ...20...