BendPak RJ-12, Installation And Operation Manual

Page: 13 / 28

13
To lower the Rolling Bridge Jack;
When lowering the Jack PAY CAREFUL ATTENTION
that all personnel and objects are kept clear. ALWAYS
keep a visual line of site on the Jack AT ALL TIMES.
1. Raise the lift up so that the Safety is off the Safety
Stop Pin.
2. Flip the Safety Handle up Off the Safety Stop Pin.
(See Fig. 6.3)
3. Press the Pedal on the lowering end. Note: the Pedal
can lock in the lowering position to facilitate lowering of
the Jack. (See Fig. 6.4)
POST-INSTALLATION CHECK-OFF
Check For Hydraulic Leaks
Check Oil Level
Lubrication of Critical Components
Check For Overhead Obstructions
Runways
Level
All Screws, Bolts, and Pins Secured
Surrounding
Area Clean
Operation, Maintenance and Safety Manuals on Site
STEP 7
(Operation)
1. Load the vehicle on the lift, following the
manufacturer’s instructions.
To Raise the Jack:
2. Position vehicle tires in the center of each runway.
3. Set parking brake or use wheel chock to hold vehicle
in position.
4. Before raising vehicle, be sure all personnel are clear
of the lift and surrounding area. Pay careful attention to
overhead clearances. Determine the proper lift points on
the vehicle by referring to the manufacture’s specification or
an approved lifting guide.
5. Check and keep clean the Utility Rails channels
clean of debris, tools, or other objects that may hinder the
movement of the Rolling Jacks.
6. Adjust the Rolling Jack Arms so that the lift pads will
make contact with the appropriate lifting points on the
vehicle as speci
fi ed by the manufacturer of the vehicle.
(See Fig. 7.1)
7. Raise the Rolling Bridge Jack by pushing on the
Raise end of the pedal of Air Hydraulic pump. Keep an
eye on the jack as the Lift pads make contact with the
vehicle to ensure that proper contact is maintained as the
weight of the vehicle is supported by the Jack.
8. Stop raising the jack just as the vehicle is raised off
the lift runways. Con
fi rm the vehicle is stable and properly
seated before lifting the vehicle to the fi nal desired height.
WARNING!
NEVER USE MORE THAN 5 INCHES OF
LIFT PAD ADAPTER HEIGHT.
Fig. 6.3
Fig. 6.4
Fig. 7.1