(+)
30
AMP
VIP 3000 POWER JACK OWNER'S INSTRUCTIONS
P/N 30826(WHITE) OR P/N 31696, 31837 (BLACK )
GENERAL SAFETY:
Read and understand the Jack installation instructions. Always block trailer wheel when using
the jack. Remove jewelry (watches, rings, etc.)
30 amp slow blow fuse
VIP Jack
travel trailer
battery
Connect the lead-wire directly to the positive (+) lead
of the travel trailer's battery using a twelve (12) gage wire.
Be sure the connection is a good one.
THE 30 AMP SLO-BLO FUSE MUST BE INSTALLED
AS SHOWN.
INSTALLATION:
IMPORTANT NOTICE:
If it is necessary to change the position of the powerhead relative to the post and flange (in order to
provide clearance between powerhead and LP gas bottle or LP gas cover, or more clearance between
the lift gate and the powerhead) loosen set screws and rotate head without lifting off coupling. Retighten
set screws when head is in desired position.
H&H ENGINEERING
DIVISION OF BARKER MFG. CO.
730 E. MICHIGAN AVE. / P.O. BOX 460
BATTLE CREEK MI 49016 / (269) 965-2371
PAGE:
DATE:
FORM #:
REV. LETTER:
ECN#:
APPROVED:
1 OF 4 21 APR 08 30842
E
13855
BEFORE INSTALLATION:
Raise your travel trailer's front end and place blocks or stabalizing jacks under the front "A" frame.
Lower the trailer until it rests securely on stabilizing jacks or blocks. Retract present jack and remove.
H&H Engineering VIP 3,000 Power Jack is designed to lift up to 3,000 pounds a full 18". It's design
also includes a night light, a build in leveling device, attached foot plate, and an emergency crank handle.
An important part of owning and using VIP Jack is being sure it is properly installed and serviced.
Remove present
jack
"A" frame coupler
IMPORTANT
To insure a good
electrical ground an
internal tooth lock-
washer must be in
place for this bolt.
Make sure powdercoat
or paint is removed from
"A" frame coupler under
washer and that tagged
hole is used.
Supplied by customer
©
Copyright H&H Engineering 1989
Install Jack in hole and secure with 3 bolts & 3 internal tooth lockwashers
(bolt holes are threaded)
Attach the foot plate to VIP Jack with .50-20 bolt and .50" lockwasher
HIGH POWER
SERIES
3000
