MAINTENANCE:
Once a year, the powerhead should be removed and a
liberal amount of grease (preferably a grease with high
melting point) applied directly to the coupling on which
the drive pin rests.
DO NOT POUR OIL into top of the jack post.
Once a year, the housing cover should be removed and
the gears inspected for proper lubrication.
Remove 4 screws and tap around edge of housing to
free cover.
DO NOT insert screw driver blade! (This may damage
mating surfaces.)
Before replacing cover, clean mating surfaces.
If lubrication is needed, use Mobilith 460 grease or
equivalent.
PAGE:
DATE:
FORM #:
REVISION LETTER: ECN#:
APPROVED:
3 OF 4 21 APR 08
30842
E
13855
H&H ENGINEERING
DIVISION OF BARKER MFG. CO.
730 E. MICHIGAN AVE. / P.O. BOX 460
BATTLE CREEK MI 49016 / (269) 965-2371
©
Copyright H&H Engineering 1989
SCHEMATIC WIRING DIAGRAM
STRAP ATTACHMENT:
1. Press strap (1) onto the stud (2) at
the bottom of the cap.
2. Press the retaining ring (3) on stud
(2) snug it down against the strap (1).
3. Repeat this process (4) on the stud
found on the inside of the cover.
THIS WILL SECURE YOUR CAP.
2
3
1
4
COVER,
INSIDE
BOTTOM OF CAP
VIP 3000 POWER JACK OWNER'S INSTRUCTIONS
P/N 30826(WHITE) OR P/N 31696, 31837 (BLACK )
P/N 16263
MOTOR
