BendPak R76LT Technical Service Bulletin Download Page 5

Page: 5 / 9

R76LT Installing the Tilt Tower

Page 5 of 9

BendPak TSB 82-092021

15.

Align the Tilt Tower and the Safety Hook. Push the Tilt Tower Safety Pin through the Tower, and

Safety Hook.

16.

Verify the Pin passes through the Safety Hook. Secure the Safety Pin with Snap Rings.

17.

Align the Cylinder Shaft, Cylinder Pin and Tilt Tower opening. Insert the Cylinder Pin through the

holes and secure with the Cotter Pins removed earlier. Bend to lock Cotter Pins in place.

18.

When the Tilt Tower is secure, you may remove the Lifting Straps or Chains from the Tilt Tower

and move the Shop Crane or Forklift away from the work area.

Summary of Contents for R76LT

Page 3: ...and Washers aside to prevent loss 10 Carefully move the Tilt Tower into place over the Tire Changer using a Forklift or Shop Crane Take care to not damage the bottom of the Tilt Tower or the Air Line exiting the Tilt Tower 11 Remove one of the Snap Rings securing the Safety Pin and remove the Safety Pin from the Tilt Tower Set these parts aside where they will not be lost ...

Page 4: ...ere they will not be lost 13 Feed the Air Line from the Tilt Tower into the Tire Changer base 14 Insert the Main Pivot Pin through the holes in the Tire Changer Base and Tilt Tower You may need to tap the Pivot Shaft lightly with a Hammer or Mallet to drive the Main Pivot Pin into place Secure the Pivot Pin with the Washers and Nuts previously removed ...

Page 6: ...and Washers 20 Locate the Black Air Line from the Tower inside the Tire Changer Route the Air Line from the Tilt Tower out the back of the Tire Changer through the open hole with a Grommet 21 Connect the Black Air Line from the Tilt Tower to the Hose Compression Coupling on the back of the Tire Changer and tighten Refer to the photo below ...

Page 9: ...ipping grease if required 2 Remove the M14 x 95 mm Bolt Lock Washer and Lock Nut from the Bead Breaker assembly 3 Insert the Bead Breaker Blade on to the Bead Breaker Arm and secure with the M14 Bolt Lock Washer and Nut just removed If you have questions about your Ranger BendPak Tire Changer go to Bendpak com support email support bendpak com or call 805 252 2363 ...