20
20
2. Remove the captive nut on the Compression Fitting.
Insert the Plastic Air line through the alignment sleeve and
into the end of the fitting until it bottoms out. Then tighten
the nut on the fitting. (See Fig 11.3)
3. Install the 90-degree Hydraulic Fitting in the port at the
ram end of the Cylinder. On the pipe thread side of the Fitting
it is recommended to use Teflon Tape or pipe sealer. DO
NOT USE TEFLON TAPE on the JIC flared end.
(See Fig. 11.4 )
4. Install the 90-degree Air Line Compression Fitting in the
port at the base, pinned end of the Cylinder. On the pipe
thread side of the Fitting, it is recommended to use Teflon
Tape or pipe sealer. (See Fig. 11.5)
5.
Route both the Power Unit Hydraulic Hose and TWO (2)
lengths of Air Line through the Flex Hose.
(See Fig. 11.6)
6.
Install the end of Flex Hose with the Straight Fitting on
the Hydraulic Hose into the hole in the Powerside Runway
adjacent to the Power Unit. Install the end of the Flex
Hose with the 90° Fitting on the Hydraulic Hose in the
Flex Hose Bracket Assy. Tighten the plastic nuts securely.
(See Fig 11.7)
Fig 11.5
Fig 11.6
Flex Hose
Power Hose
Air Line Hose
90° Hose End
90° Air Line
Compression
Fitting
Fig. 11.7
Fig. 11.3
90° Air Line
Compression
Fitting
90° O-Ring
Fitting
Fig. 11.2
90° Hydraulic
Fitting
Fig 11.4
