23
ALL WIRING MUST BE PERFORMED BY A CERTIFIED ELECTRICIAN ONLY.
PROPER WIRING INSTRUCTIONS ARE AFFIXED TO THE MOTOR.
Identify which Power Unit the lift was shipped with by looking on the data tag affixed to the Power Unit
motor head. if the model number begins with the letter “S” then use the “S” wiring diagrams.
If the model number begins with the letter “E” or “F” then use the “E” or “F” wiring diagrams.
IMPORTANT POWER-UNIT
INSTALLATION NOTES
n
DO NOT run power unit with no oil. Damage to pump can occur.
n
The power unit must be kept dry. Damage to power unit caused by water or other liquids such as
detergents, acid etc., is not covered under warranty.
n
Improper electrical hook-up can damage motor and will not be covered under warranty.
n
Motor can not run on 50HZ without a physical change in motor.
n
Use a separate breaker for each power unit.
n
Protect each circuit with time delay fuse or circuit breaker.
n
For 208-230 volt, single phase, use a 25 amp fuse.
n
For 208-230 volt, three phase, use a 20 amp fuse.
n
For 380-440 volt, three phase, use a 15 amp fuse.
Installation and adjustment.
DO NOT attempt to raise vehicle until a thorough operation check has been completed.
DO NOT PERFORM ANY MAINTENANCE OR INSTALLATION OF ANY COMPONENTS
WITHOUT FIRST ENSURING THAT ELECTRICAL POWER HAS BEEN DISCONNECTED AT
THE SOURCE OR PANEL AND CANNOT BE RE-ENERGIZED UNTIL ALL MAINTENANCE
AND/OR INSTALLATION PROCEDURES ARE COMPLETED.
