BENDIXKing KI 300, Installation Manual

Page: 36 / 50

____________________________________________________________________________
89000004-101 KI 300 Installation Manual
Rev 1 Page 4-9
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Each pages ’ value is internally stored when the corresponding page is exited, not upon exit of the last
page.
4.7.3 Setup Pages
A total of 29 setup pages are available as follows:
Table 4-2: KI 300 Setup Parameters
Setup Page Purpose
Min
Value Max
Value
Increment
Reference
Section
Pitch Trim Used to adjust for various panel tilts. -45° +45° 0.1° 4.7.3.1
Roll Trim Used to adjust for minor variations in roll. -5° +5° 0.1° 4.7.3.1
Panel Type Hard Mount / Float Mount Hard Float n/a 4.7.3.2
ADC Display
Used to enable/disable Airspeed and Altitude
tapes (IAS/BCA, IAS Only, BCA Only, No
IAS/BCA)
n/a n/a n/a 4.7.3.3
ADC Calibration
Enter Air Data Computer (ADC) Calibration?
No skips to Vs0 menu item.
No Yes n/a 4.7.3.4
IAS Trim @
30 knots Used to adjust for minor variations in airspeed
at 30 knots.
-50 +50 1kt or mph 4.7.3.4
IAS Trim @ 400
knots Used to adjust for minor variations in airspeed
at 400 knots.
-50 +50 1kt or mph 4.7.3.4
ALT Trim @
0 ft Used to adjust for minor variations in altitude
at 0 ft.
-999 ft +999 ft 1ft 4.7.3.4
ALT Trim @
35,000 ft Used to adjust for minor variations in altitude
at 35,000 ft.
-999 ft +999 ft 1ft 4.7.3.4
Vs0 Used to set Vs0 band on IAS indicator. 0 400 1 kt or mph 4.7.3.5
Vs1 Used to set Vs1 band on IAS indicator. 0 400 1 kt or mph 4.7.3.5
Vfe Used to set Vfe band on IAS indicator. 0 400 1 kt or mph 4.7.3.5
Vno Used to set Vno band on IAS indicator. 0 400 1 kt or mph 4.7.3.5
Vne Used to set Vne band on IAS indicator. 0 400 1 kt or mph 4.7.3.5
Vyse
Used to set Vyse mark on IAS indicator.
0 Disables.
0 400 1 kt or mph 4.7.3.5
Vmc
Used to set Vme mark on IAS indicator.
0 Disables.
0 400 1 kt or mph 4.7.3.5
IAS Units Used to set units for IAS (KTS or MPH) n/a n/a n/a 4.7.3.6
Baro Units Used to set baro units (inHg or Mb) n/a n/a n/a 4.7.3.7
Baro Default
Used to set default baro settings (STD, AUTO,
LAST)
n/a n/a n/a 4.7.3.8
IVSI Damping
Used to disable display of IVSI, or enable IVSI.
Also used to set the display filtering. (OFF,
0..10 seconds)
0 sec 10 sec 1 sec 4.7.3.9