89000046-014
KSN 780/8XX/900 AeroNav AML STC Installation Manual for Helicopters
Rev 0
Page 7-22
© Honeywell International Inc. Do not copy without express permission of Honeywell.
The following parameters can be tested:
CDI (LAT/VERT)
Selection
Description
Max Left
The remote CDI will be off-scale full deflection to the left/up
Full Left
The remote CDI will be deflected to the left/up
Center
The remote CDI will be centered
Full Right
The remote CDI will be deflected to the right/down
Max Right
The remote CDI will be off-scale full deflection to the right/down
Table 97 Main CDI Test Page
NAV Flag (LAT/VERT)
Selection
Description
Hidden
The lateral and vertical flag on the external indicator is hidden
In view
The lateral and vertical flag on the external indicator is in view
Table 98 Main CDI Flag Test Page
TO-FROM
Selection
Description
FROM
The FROM flag on the external indicator is in view
Hidden
The TO/FROM flag on the external indicator is hidden
TO
The TO flag on the external indicator is in view
Table 99 Main CDI Flag Test Page
Selected Course
This section will calibrate the external CDI/HSI to the AeroNav XXX.
1.
Select 150° on the CDI/HSI;*
2.
Verify the Selected Course is displayed on the AeroNav XXX and press the ENTR button on
the AeroNav XXX;
3.
After calibrating, verify 30° increments on the CDI/HSI are properly displayed on the
AeroNav XXX ±2
°
.
*
In order to do the OBS calibration on a KI208A or KI209A, you have to toggle to the "Main
Discrete I/O" page, and turn "ON" the GPS discrete toggle. Then turn to the Main CDI/OBS
config page (without toggling back to the Discrete I/O page) and calibrate the OBS by dialing
150 degrees on the indicator.
