Bender ISOMETER IRDH575, Manual

Page: 114 / 120

115
IRDH575_D00089_05_M_XXEN/01.2020
D
Dimension diagram enclosure 110
Display in the menu mode 41
E
EDS4...
- Common message 28
- Max. test current, setting 60
- Start and stop conditions, setting -
auto, on, off, pos, 1cycle 58
- Type of the system, setting (DC/1AC/
3AC) 60
EDS46.../49...
- Adapting frequency converters to the
system being monitored (inverter)
66
- Assigning an EDS Alarm to one or
both common relays (Alarm
on/off) 67
- EDS test (test of all BMS bus nodes)
68
- Setting delay on response, T(off) 66
- Setting response values (ResVal) 66
- Setting the CT type (CT-W/WR) 66
- Setting the memory behaviour of an
EDS. 63
- Setting the nominal frequency 64
- Setting the operating mode of the 12
channel-related alarm relays
(Channel/Op.mode, only EDS490/
491)
67
- Setting the operating mode of the
common alarm relays alarm1 and
alarm 2 (Relay/op.mode) 67
- Setting the response delay, T(on) 66
- Setting the system coupling (DC/1
AC/3 AC) 64
- Starting the EDS with IRDH575 or
continuous EDS mode (Trigger) 63
- To enable or disable the CT monito-
ring (CT monitor) 66
EDS470/473
- CT Setup 73
- EDS monitor - indication of all de-
tected insulation faults 70
- Elongation of the measuring time 74
- Memory behaviour of EDS4...-12,
setting 73
- On or off switching of the CT monito-
ring 73
- Operating principle of the alarm re-
lays of EDS47..., setting 73
- Reset 70
- Test of all BMS bus nodes 70
Essential functions, ISOMETER 17
External coupling devices 55
External RESET button 32
External TEST button 32
F
Factory settings 89
Fault messages, language setting 78
Flashing point 83
Function 19
Function input F1/F2 22