Page 8
1.0 DESIGN
1. 2 TECHNICAL DATA
Model Selection Guide
General selection criterion is shown in Technical Data table 2.1. However, before
selecting the model, the hot water requirements of the dwelling should be correctly
assessed. If the appliance is to be installed in a cupboard, then the minimum
dimensions and clearances specified in figure 1.4 must be observed.
Appliance Location
The Accolade must be installed on a flat surface, which is capable of supporting the
weight of the appliance and any other ancillary equipment.
The minimum airing cupboard dimensions and the clearances required for installation
and service are shown in figure 1.3.
The appliance is designed to be installed on the plinth supplied with the appliance.
The pipe connection arrangements for the direct and the indirect models are shown
in figures 1.4 and 1.5.
Top
Bottom
Boiler Flow
Boiler Return
Heating Flow
Heating Return
Hot Outlet
Discharge Pipe
Balanced Cold Outlet
Cold Inlet
Drain Cock
Primary Expansion
(SS Model)
Combined Safety/Open Vent &
Cold Feed/Expansion
(OV Model)
Cut out area through
base of unit
figure 1.4 Connection Arrangement - Indirect
figure 1.5 Connection Arrangement - Direct
