16
7. Align the holes and insert the cotter pin
by hand (Fig.16).
Cotter Pin
NOTE:
Before using this machine, make sure that the power source you will use
complies with the specifications detailed in this manual. Before inserting the battery
to start, verify that the snowblower’s roll shaft and rubber plates are firmly secured
with screws, and that the rubber plates are facing the correct direction. Perform a
test run to ensure that the motor turns freely.
CHARGING THE BATTERY PACK
NOTE:
Remove the battery pack from the charger after it has been fully charged.
NOTE:
Battery should be fully charged before first use.
NOTE:
Make sure the mains voltage is the same as the rating label which is located
on the charger.
1. Connect the charger to a power supply. The red LED will light up.
2. To insert the battery pack into the charger, align the raised ribs of the battery
pack with the grooves of the charger then push it in (Fig.17).
3. The green LED light of the charger will flash continuously during normal charging.
4. After charging is complete, the charger light will turn to a solid green light.
POWER INDICATOR (Fig.18)
This Li-Ion battery pack is equipped with a power indicator which is used to show
the battery packs remaining charge. Press the power indicator button to check
battery charge. The LEDs will stay lit for approximately 4 seconds.
5554-514
22" CORDLESS SNOW BLOWER
Fig. 16
Fig. 17
Fig. 18
