Benchmark Games Acme Crane Company, Manual

Page: 9 / 22

Playfield Floor Height Adjustment
sts as product is won. If you are not using The playfield floor automatically adju
this feature, the floor can be manually adjusted.
•
Press the SW1 button
1
on the power distribution pcb
2
in order to
•
lower the floor. When this button is pressed, the floor will will be
lowered to its lower limit.
Press the SW3 button
3
to raise the floor height. Each time the SW3
button
4
is pressed, the floor will raise 4 inches.
ip Switch Settings D
witch the game off before adjusting the dip switches
S
1 .
The dip switches
1
are located on the controller board
2
.
Not Used
ollar Value Setting . This switch setting is used to match the coin to dollar value based on pulses
to
Value
uto Plushing
fluffs” the plush during attract mode to keep the merchandise from packing.
isabled
ttract Sounds
lay approximately every 5 minutes when the game is not being played when
isabled
Dip 2
ip 4
Dip 1
D
output by the dollar bill validator. The factory setting is 1 (Off/Off). This creates a 4:1 coin to
dollar value when the DBV is set to 4 pulses per dollar. If your dollar bill validator is set up to
output 1 pulse per dollar, you will need to set the switches to 4 (On/On) in order to get a 4:1 coin
dollar value.
Dip 3 D
1
2
3
4
A
Auto Plushing “
Dip 5
D
Enabled
A
Attract sounds p
enabled.
Dip 6
D
Enabled
8
- -
- -
- -
- -
Off Off
On Off
Off On
On
On
On
Off
On
Off
Custom coin: dollar values used for adjusting to different currencies can
alue (Dip Setting) x Pulses per Dollar (DBV)
be set using this formula:
Dollar V
P e ar= r Doll Plays per Coin (programmable option #1) lays p