the merchandise side to keep the containment plate from falling over.
Load the game w
•
ith merchandise.
djust game volume, claw pressure, and programmable options as necessary. See Game
ote: Do not remove the casters. The game requires the additional height in order to
djustments and Settings
etting Claw Strength
A
Adjustments section.
N
properly operate with full playfield floor travel.
A
S
y adjusting
The claw strength is set b
the needle valve
1
which sets the
nominal air pressure. The air press
is indicated on the air pressure gage
ure
2
when the pump
3
is running.
To adjust the claw strength:
1. Put the game into adjustment
mode by holding the crop claw
button on the control panel
and the SW2 button
4
on th
pump for 60 seconds.
Turn the needle valve
1
e power distribution pcb
5
sim
2.
ultaneously. This will run the
to set the pressure. The pump will shut off on its own after 60
NOTE:
recommend starting with 4 psi as a starting point. After a week, check the payout
ressure
etting the Sound Volume
seconds.
We
percentage and adjust if necessary. Set the pressure higher to increase payout, reduce p
to decrease payout.
S
l knobs
There are two volume contro
1
on the controller board
2
used to adjust
volume. Turn to adjust to desired level.
7
Summary of Contents for Acme Crane Company
Page 1: ...70 MAN C...
Page 2: ...1...
