Technical Documentation
KSR-V – Capacitor-Bank Protection Relay
Rev. 05
13
5.5 Submenu "setup"
The “setup”-menu contains all settings, which can be performed by the user of the KSR-V to adjust it to
certain ambient circumstances. To enter this submenu, a password is necessary. The fixed password is
"2402". Because there are many possible settings, the "setup"-menu divides up into more submenus to
provide easy and logical access to the setup features:
parameter:
This submenu provides the possibility to set certain system parameters, like transformer
ratios and others.
modbus:
This submenu contains all settings for the Modbus interface.
relay:
This submenu allows to set the relay inversion for alarm relays and the setting "manual reset"/
"automatic reset".
alarm:
This submenu contains the settings for the 32 alarms.
Load default:
This resets all relay settings, parameters and alarm settings to standard values.
Reset relays.:
This resets all relays, which are
configured with the “manual reset” setting. By
selection of this menu entry, the relays are set back to inactive state. A new alarm will re-activate the
hold state for the relay.
KEYS:
Select a submenu with the arrow-keys ("
" and "
") and enter it by pressing the "
" - key. You may get to
another submenu or be prompted for confirmation. You can confirm by selecting "yes".
The left key ("M") switches back to the main menu.
5.5.1 Input of numerical values
Inside the "setup"-menu and its submenus, the user will at certain points encounter the problem to enter
numerical values. Whenever the KSR-V prompts for the input of a value, the routine will be the same:
A preset-value will be displayed with the first (highest) digit underlined by a "_". This digit can now be
changed by use of the keys which are labelled with "+" and "-" signs. If no change can be encountered while
pressing these buttons, the value may be at its minimum or maximum, so just try the other key or change to
the next, smaller digit by use of the "
" key. After changing, the next digit will be also underlined with a "_"
and can now be altered just like the first one. To store the value, proceed to the least significant digit on the
right side. Press the "
" key once more, and the new value will be saved and used.
At any time, one can go back to the menu he came from without changing the value by pressing the “
” key.
In this case the modified value will
not
be used!
