Belshaw Adamatic Bakery Group
•
www.belshaw-adamatic.com
•
206-322-5474
•
Donut Robot
®
Mark VI Operator’s Manual
MN-1032EN
15
5
Accessories
This section contains information about accessories which can be used with your Donut Robot
:
FT2DW Feed Table
Figure 7 FT2DW Feed Table, with Feed Table cloth.
The FT2-DW Feed Table is designed to supply
proofed yeast-raised donuts to the Mark VI.
The Feed Table produces less than 70 dB(A) of
equivalent continuous A-weighted sound
pressure at work stations. This has been
determined while the machine has been running,
using a Bruel & Kjaer Sound level meter, type
2236.
The Feed Table is meant to be used on a flat,
stationary table or countertop, positioned end-to-
end with the Donut Robot. The operator is
expected to read and follow these instructions
and warnings.
Installation
1. Unplug the depositor power cord of your
Donut Robot.
2. Release the plunger from the depositor.
3. Unscrew and lift off the hopper assembly.
4. Lift off the depositor and swing column.
5. Lift the outfeed end of the Feed Table and
set the brace under the trip shelf over the
edge of the kettle.
WARNING
To avoid injury, make sure that the Feed
Table is turned off before proceeding.
6. Plug the Feed Table power cord into the
outlet on the end of the heater head.
7. Set the switch on the control panel to “Feed
Table”.
