25
G87
CLEANING AND MAINTENANCE
TURN OFF THE OVEN ELECTRICITY SUPPLY BEFORE
CLEANING.
OVEN EXTERIOR
All the parts of the oven exterior (stainless steel, side
panels, door glass) must be cleaned frequently with a
mild detergent and a little water and then dried with a
soft cloth.
Do not wash the parts if they are still hot and never use
abrasive powders, pads or corrosive spray products.
Do not leave vinegar, coffee, milk, salty water or the
juice of lemon or tomato on the surface for any length
of time.
On painted or stainless steel surfaces, do not use
solvents to remove spots or label adhesive.
Stainless steel cleaner can be obtained from the Belling
Spares department tel. 01709 579907, quoting
reference number Belling 005.
OVEN CAVITIES
The oven should be cleaned after each use to remove
cooking residuals and grease which, if burnt on when
the oven is used again, will form deposits or stains, as
well as unpleasant smells. Do not leave vinegar, coffee,
milk, salty water or the juice of lemon or tomato on
enamelled surfaces for any length of time. Always wash
the accessories used. The rod shelves, heat deflector
shield and grill can be cleaned using household cream
cleanser with a nylon pad or sponge. Heavier soiling
may require the use of a proprietary oven cleaner or
steel wool pad, but do not allow these to contact the
door seals or plastic parts of the oven.
Only use oven cleaners which carry the Vitreous Enamel
Development Council’s Approvals symbol, and always
follow the manufacturers instructions for use. Do not
spray or wash the elements or thermostat bulb with
acid-based products (check the information label on
the product you are using).
The manufacturer cannot be held responsible for
any damages caused by incorrect cleaning.
OVEN DOOR SEAL
The oven door seal guarantees the correct functioning
of the oven. We recommend you:
•
clean it, avoiding abrasive products.
•
check its condition from time to time.
CHANGING THE OVEN LAMP
WARNING: TURN OFF THE OVEN ELECTRICITY SUPPLY
BEFORE REPLACING LAMP.
Open the oven door and remove the rod shelves. Use a
thick cloth to grip the light glass lens (C) and bulb,
unscrew anti-clockwise and lift out.
Reach into the aperture, and carefully unscrew the faulty
lamp (L) anti-clockwise. Fit replacement lamp (15W
300°C SES), and refit lens. If necessary clean the lens
in warm soapy water before drying completely.
NOTE: Oven bulb replacement is not covered by your
guarantee, please telephone our Spares Department
on 01709 579907 for a replacement.
L
C
P
M
