Step 1: Prepare for installation
There are 4 methods of installing
the appliance:
Method 1:
Into a space between two
base units, ie; without a housing unit.
Method 2:
Into a housing unit, with
an internal height of less than 710mm,
which can be modified to obtain the
required dimensions.
Method 3:
Into a housing unit, with
an internal height of 710mm or more.
If you have a non standard size of
cabinet dimensions.
which leaves a gap above or below
the appliance, you may be able to buy
a trim kit (to fill in the gap) from the
supplier of your cabinets.
Method 4:
Into a tall housing unit with an internal
height of 710mm or more. (As method
3 above.
Method 1
:
Without housing unit
(between 2 base units)
Before installing the appliance, check
the internal dimensions as shown.
The space for the appliance must be
clear of obstructions and there must be
enough space at the back of the oven
for the gas inlet pipe to hang freely.
You may have to cut into or remove
any rear cross members from the
housing unit to obtain the 550mm
minimum depth
The Fixing Kit
If you require a replacement fixing kit
please call:
0870 458 9961
and order part
number:
01 28287 00
.
In the fixing kit you will find 2 side
trims (687mm long) and 4 runners
(420mm long). The fixing screws are
in a polythene bag in the oven.
1. Take the 6 n
o
8 x 12mm long
(silver) self tapping screws from
the polythene bag, and use them
to fit one runner to each side of the
appliance.
2. Make sure they are the right way
up as shown.
3. Take one of the side trims, hold it
against the side of the base unit,
and mark off 687mm from the top
edge of the base unit, to the top
edge of the runner.
Note:
This ensures a 5 - 8mm
clearance from the underside of the
worktop to the top of the appliance.
4. Measure 50mm from the front
edge of the base units, to mark the
front edge of the runners.
5. Take 6 of the n
o
8 x 12mm (black)
chipboard screws and screw the
runners into position the right way
up as shown.
6. Fit the side trims to be flush to the
top and front edges of the base
units, using the remaining 6 n
o
8 x
12mm (black) chipboard screws.
19
Installation Instructions
27353 00 - Belling GG720 14/6/07 14:59 Page 21
