Bellfires HORIZON BELL SMALLTUNNEL 3, Installation Instructions And Instructions For Use

Page: 14 / 102

14
Bell fi res
English
Instructions for use and installation instructions
Manual operation
Here you can turn the burner on and off, and adjust the height of the fl ames.
• Press (large fl ame) to turn on the burner and to increase the fl ame
height.
• Press (small fl ame) decrease the fl ame height to turn the burner off.
The pilot light will keep burning. (Stand-by position)
• The appliance will automatically revert to stand-by if :
°
the hand-held transmitter is outside the range of the receiver for more
than 6 hours.
°
the batteries in the hand-held transmitter are almost depleted .
°
the batteries in the receiver are fully depleted . (The pilot light will also
be turned off.)
This also applies to the Thermostat and Timer operation.
• When one of the button s on the hand-held transmitter is pressed (except
the SET button ), the transmission symbol appears on the screen.
The receiver confi rms the transmission with an audio signal.
Operating day temperature thermostat
(Appliance is in the stand-by position and the pilot light is burning.)
Automatic temperature regulation of the pre-set day temperature.
The room temperature is measured and compared with the pre-set day
temperature. The fl ame height is automatically regulated so as to reach the
pre-set day temperature.
Also see: Setting the desired temperature .
Operating possibilities
It is possible to use the remote control in 3 ways to operate the appliance:
1 :
2 : and
3 :
You can cycle through the menu with operating possibilities by repeatedly depressing
the SET button.
At the selected starting time (P1 or P2 ) or stopping time (P1 or P2 ) is
also shown.
Returning to is also possible by pressing the (small fl ame) or (large fl ame)
button
.