Bellfires Corner Bell Large, Installation Instructions And Instructions For Use

Page: 16 / 99

17
Bellfires
English
Instructions for use and installation instructions
l
Move the operating knob to the ON position. Depending on the position of the motor-
knob, the burner will either ignite or not.
l
By turning the motor-knob anti-clockwise to the desired position, the burner will ignite
and the flame height can be controlled.
Extinguishing the fire
l
Turn the motor-knob on the gas regulating block as far as it will go in a clockwise
direction. The knob will audibly ‘click’. The burner is now switched off. The pilot light
will remain lit.
Switching off the appliance
l
Press the “O I” switch on the gas regulating block to the “O” position.
The pilot light will be extinguished.
l
If the gas fire is not going to be used for a long period of time, it is
recommended to close the gas supply valve to the fire.
Important: If the pilot flame goes out for any reason,
wait for 5 minutes before attempting to
re-light it.
2.6 USING THE APPLIANCE FOR THE FIRST TIME
The gas fire is coated with a lacquer layer resistant to high temperature. During the first
hours of operation, the burning in of the lacquer may result in an unpleasant smell. This
is harmless, however. Operating the gas fire at full capacity for a few hours, while
ventilating the room, will eliminate the smell.
After using your gas fire for the first few times, you may be aware of a light deposit
behind the glass. This is caused by the paint curing. Once your fireplace has cooled
down, this deposit can be removed with glass cleaner or ceramic hob cleaner.
2.7 DAILY MAINTENANCE
l
Ensure that as little dust, and as few particles of cigarette smoke, candles and oil
lamps as possible pollute the air in the room in which the appliance is used. Heating
of these particles by the convection system of the appliance could lead to
discoloration of the walls and ceiling. It is therefore very important to ensure that the
room in which the appliance is located is sufficiently ventilated. Regularly remove
any dust deposits from behind the control flap by means of a vacuum cleaner.
Important: If the glass is broken or cracked, it must be
immediately replaced before operating the
gas fire again.