Page 1
OPERATIONS AND MAINTENANCE PROCEDURES
CONVEYOR OVEN MODELS
JSO-14 JPO-18
UNCRATING AND INSPECTION
Unpack the unit and components from the shipping container. Remove all visible packing
materials including those that may be inside the baking chamber. If damage is discovered, file a
claim immediately with the carrier that handled the shipment.
ASSEMBLY AND INSTALLATION
The equipment is shipped fully assembled and ready to plug into a matching outlet specified for
its specific voltage and amperage rating. Removal or replacement of the power cord and plug
will VOID the warranty. For assistance, contact the Belleco, Inc. Service Group at 1-877-854-
8006. Please refer to the appropriate schematic at the rear of this manual for plug configurations.
Consult with a licensed electrician prior to installation.
"
Do not operate this equipment without
the crumb trays properly installed as this may cause overheating and loss of productivity.
CAUTION – During installation: Do not place on surfaces or near walls, partitions or
kitchen furniture and the like – unless they are made of non-combustible material or clad with
non-combustible heat-insulating material, and pay attention to fire prevention regulations.
CAUTION – To reduce the risk of fire, the appliance is to be installed in non-
combustible surroundings only, with no combustible material within 18 inches of the sides, front,
or rear of the appliance or within 40 inches above the appliance. "Food may burn. Therefore
equipment must not be used near or below curtains and other combustible materials. They must
be watched."
ELECTRICAL INSTALLATION
WARNING – Disconnect the unit from its power source before installing or removing
any parts.
WARNING – Check with your local power company or licensed electrician before
installation to determine the actual voltage at the outlet. For a unit rated 208 volts, never plug it
into 240 volts as serious overheating and damage could occur. For a unit rated 240 volts, never
plug it into 208 volts as the lower voltage will greatly reduce the productivity of the unit.
WARNING – NEVER operate any piece of equipment without proper GROUND
connection. Improper grounding may result in serious personal injury or could be fatal!
