SECTION
573-127-703
2. 05
Tape Lid (continued)
STUD
GAUGE
WEAR PLATE
TAPE
GUIDEPLATE
CENTER STUD
TAPE GUIDEPLATE
(Top View)
MOUNTING NUTS
TAPE GUIDE
To Check
Unlatch tape lid and position gauge as
illustrated.
(1}
Requirement
some---Max
0.003
inch
between gauge and each tape
guide.
(2)
Requirement
of wear plate flush with edge
of tape guideplate.
(3)
Requirement
Tape must not ride up the sides
of the tape guides.
To Adjust
Loosen mounting nuts. Position wear
plate until it overhangs tape guide
plate. Push gauge down until top two
studs butt up against tape guideplate
thus positioning edge of wear plate
flush with edge of tape guideplate.
Hold gauge and wear plate and position
each tape guide to meet Requirement
(1}.
Tighten mounting nuts.
Note: Tape guides may touch gauge,
but they must not bind against gauge
when it is removed.
TAPE-OUT
PIN HOLE
(Bottom View)
Page
8
