BELL LABS INNOVATIONS Lucent Technologies Stinger MS+, Getting Started Manual

Page: 11 / 100

Stinger® MS+ Getting Started Guide xi
Tables
Table 1-1 Control module model designations and product codes ................... 1-7
Table 1-2 Control module models and features ................................................ 1-8
Table 3-1 Status lights on the control module .................................................. 3-4
Table 3-2 Fan status light .................................................................................. 3-5
Table 4-1 Location of configuration information .............................................. 4-5
Table 5-1 IP address classes and number of network bits ............................... 5-10
Table 5-2 Decimal subnet masks and prefix lengths ....................................... 5-11
Table B-1 Diagnostic port and cable pinouts ..................................................... B-1
Table B-2 Alarm input pinouts .......................................................................... B-2
Table B-3 Single or lower connector pin assignments for two-wire
connections ....................................................................................... B-4
Table B-4 Upper connector pin assignments for two-wire connections............ B-5
Table B-5 Middle connector pin assignments for two-wire connections
(72-port LIM only) ............................................................................ B-6
Table B-6 Lower connector pin assignments for four-wire connections........... B-7
Table B-7 Upper connector pin assignments for four-wire connections ........... B-8
Table C-1 Stinger electronic and electrical specifications .................................. C-1
Table C-2 Stinger T1 module USOC jacks and codes......................................... C-2
Table C-3 Stinger FS minimum ground wire sizes ............................................ C-3
Table C-4 Stinger MS+ physical specifications .................................................. C-3
Table C-5 Stinger MS+ site specifications .......................................................... C-4