2-4
Stinger® MS+ Getting Started Guide
Installing a Stinger MS+
Connecting cables to a Stinger unit
Figure 2-2. LPM 50-pin connector
Note
Connections for 64-pin connectors are secured by anchor screws on the top
and bottom of each connector.
Connecting the subscriber lines
In the rear of the chassis, cables are routed toward the left, as shown in Figure 2-3, to
allow for removal and replacement of the cooling module.
Use the following procedure to connect the cables to the line ports of an LPM with
50-pin RJ-21 connectors, installed in the Stinger MS+ unit:
1
Carefully insert the on the line connections of the LPMs in the Stinger MS+ unit,
as shown in Figure 2-3.
Figure 2-3. Connecting to LPMs in a Stinger MS+ unit
Note
See Figure 2-2 for details of the connector locking tab, anchor screw, and cable
cinch-tie.
2
Push the cable connectors onto the chassis connectors until each locking tab is
engaged.
3
Tighten the anchor screw on each cable connector.
Anchor
screw
Cinch-tie
Locking tab
Locking tab slot
TM
1
2
3
4
CAUT
ION
MOVING
PARTS
GREE
N-ACT
IVE
RED-F
AILED
POR
T
25-48
POR
T
25-48
POR
T
25-48
POR
T
25-48
POR
T
49-72
POR
T
49-72
POR
T
49-72
POR
T
49-72
POR
T
1-24
POR
T
1-24
POR
T
1-24
POR
T
1-24
POR
T 1
POR
T 2
