BELINEA 10 55 70, Service Manual

Page: 9 / 80

11. Remove the CRT anode cap. Refer to the figure 2-9
12. Place the diiplay flat on its face and remove the nylon
holding the main board in place on the frame.
Refer to the figure 2-9
2.9.
Removing the Neck
Board and
Main Board
Disconnect the three ground wires from the metal casing
of the neck board. Refer to the figure 2-10 (A).
2 . Remove the two Lock Caps from the nylon ties. Refer
to the figure 2-10
3 .
Remove the Neck Board from the CRT.
4 . Remove the Main Board.
Figure Removing the Main Board
2.10. Removing the Control PCB
Remove the two screws from Cover. Refer to the
figure (C).
2. Remove the seven screws Control Panel. Refer to
the figure (A).
3 .
Remove the Control Board.
Figure Removing the Control PCB