BELINEA 10 55 70, Service Manual

Page: 6 / 80

??
VA Version
2.1. Removing the Rear Cover
1. Turn the display so it is resting face downwards on the
work surface. Be sure to place a cloth or other soft
material on the work surface to avoid scratching the
screen surface.
2 . Remove the four screws at the rear of the display. Refer
to the figure 2-l (A).
3. Remove the rear cover.
Figure Remove the Rear Cover
2.2. Internal Disassembly (Right Side)
The neck board is plugged on to the CRT neck and is enclosed
in a metal shielding.
1. Disconnect the two ground wires from the Neck Shield.
Refer to the figure 2-2 (A).
Figure 2-2 Disassembly (Right Side)
2 . Remove the connected pin from the Neck Board. Refer
to the figure 2-2
3 . Remove the screw at the rear chassis. Refer to the figure
2-2
4. Cut the two cable ties indicated to free the cables. Refer
to the figure 2-2
5 . Disconnect the degaussing coil from the Main Board.
Refer to the figure 2-2
6 . Release the cable wire indicated to free the cables. Refer
to the figure 2-2
7 . Remove the nylon revets holding from Bezel. Refer to
the figure 2-2 (G).
2.3. Internal Disassembly (Left Side)
Cut the four cable ties indicated to free the cables. Refer
to the figure 2-3 (A).
2. Disconnect the three ground wires from the Neck
Shield. Refer to the figure 2-3 (B).
3. Remove the screw at the FBT cover. Refer to the figure
2-3 (C).
4 . Remove the nylon revets holding from fix plate. Refer
to the figure 2-3
5 . Remove the connected pin from the Logic Board. Refer
to the figure 2-3
6. Remove Logic Board.
7 . Remove the connected pin from the Connector Board.
Refer to the figure 2-3
8. Remove the two connected pins from the Main Board.
Refer to the figure 2-3 (G).
Figure 2-3 Internal Disassembly (Left side)
2-l