7
STEP 5: When the temperature indicator light switches off after approx. 25 seconds,
remove the iron from the iron stand and use as a cordless iron.
STEP 6: Put the iron back onto the iron stand to recharge any point. Recharge time is
approx. 5 seconds.
Using as a Corded Iron
STEP 1: Check that the iron is switched off and unplugged from the mains power supply.
STEP 2: When the iron is on the iron stand, make sure that the heel of the iron is pushed
back and is secure.
STEP 3: Move the locking switch to the corded position. This will lock the power unit to
the iron.
STEP 4: Plug in and switch on the iron at the mains power supply.
STEP 5: Remove the iron from the iron stand and use as a corded iron.
Note: When the iron is not in use, keep the locking switch in the
‘locked’ position in the centre. This is ideal for storage.
Ironing with Steam
The steam settings are ideal for removing creases from fabrics such as cotton and linen
with ease.
STEP 1: Fill the water tank following the instructions in the section entitled ‘Filling the
Water Tank’.
STEP 2: Plug in and switch on the iron at the mains power supply.
STEP 3: To increase the temperature of the iron, rotate the temperature control dial in
a clockwise direction until the desired heat setting is reached. Reduce the temperature
by rotating the temperature control dial in an anticlockwise direction. The temperature
indicator light will illuminate to signal that the iron is heating up; this will switch off once
the iron is ready to use. The iron will only produce steam when the temperature control
dial is set to the 3-dot heat setting.
STEP 4: Select the desired steam setting by pressing the steam control trigger until
either ‘1’ or ‘2’ is visible on the steam setting indicator. The steam setting can be
switched off at any time by pressing the stream control trigger until it reaches ‘0’.
STEP 5: After use, rotate the temperature control dial to the ‘Off’ position. Switch off and
unplug the iron from the mains power supply and allow to cool thoroughly.
Note: Allow the iron to reach the desired heat setting before
use; not doing so may cause water to drip from the water tank.
The temperature indicator light will illuminate whilst the iron
is heating up but not when it is cooling down; it should not be
misinterpreted as a ready-to-use indicator light.
