11
Problem
Possible Cause
Possible Solution
Reduced constant
steam or no
constant steam.
The steam holes
are blocked.
The steam control is
set to ‘0’.
Clear the steam holes of any blockages.
Select a steam setting using the steam
control trigger.
The fabric shows
signs of melting.
The temperature
selected is too high.
Reduce the temperature using the
temperature control dial.
The iron will not
turn on.
The iron is not
connected to the
mains power supply.
The fuse in the mains
plug has blown.
Plug in and switch on the iron at the mains
power supply.
Replace the fuse in the plug with one of
the same rating.
Water does not
spray out of the
spray nozzle.
There is no water in
the water tank.
The iron is being
used for the first time.
Fill the water tank following the instructions in
the section entitled ‘Filling the Water Tank’.
Press the spray button several times until
water is released from the spray nozzle.
The iron is not
removing the
creases from
the fabric.
The temperature is
set too low.
The steam control
trigger is set to the
‘Off’ position.
Increase the temperature using the
temperature control dial, ensuring that the
fabric’s care instructions are followed.
Select a steam setting using the steam
control trigger.
Water is leaking
from the soleplate.
The temperature is
set too low.
The iron has not
been recharged.
Increase the temperature using the
temperature control dial, taking care that the
fabric’s care instructions are followed.
Put the iron back onto the iron stand to
recharge any point. Recharge time is
approx. 5 seconds. If ironing with steam for
prolonged periods of time, it is advisable to
use the iron as a corded unit.
Specifications
Product code: BEL0747N
Input: 220–240 V ~ 50/60 Hz
Output: 2600 W
Water tank capacity: 300 ml
