6
Instructions for Use
Before First Use
STEP 1: Switch off and unplug the iron from the mains power supply.
STEP 2: Wipe the exterior surface of the iron with a soft, damp cloth and dry thoroughly.
STEP 3: To remove any impurities that may have occurred during the manufacturing
process, it is best to use the iron on an old piece of cloth, making sure that it is on the
highest temperature setting suitable for the material. Plug in and switch on the iron at
the mains power supply, place the iron onto the cloth and then push the steam burst
button 2–3 times, waiting approx. 5 seconds in-between each burst; this will remove any
impurities from the ceramic soleplate.
Do not immerse the iron in water or any other liquid.
Note: When using the iron for the first time, a slight odour and
a small amount of smoke may be emitted. This is normal and
will soon subside. Allow for sufficient ventilation around the iron
when it is in use.
Filling the Water Tank
STEP 1: Switch off and unplug the iron from the mains power supply.
STEP 2: Check that the steam setting indicator is set to the ‘0’ position (off).
STEP 3: Place the iron onto the iron stand and open the water tank cap.
STEP 4: Fill the measuring jug with water, without exceeding the Max. fill mark. Carefully
pour the contents of the measuring jug into the water tank.
STEP 5: Close the water tank cap.
Caution: Do not fill the water tank past the max. fill mark; it is best
to check the water level when the iron is positioned upright.
Warning: Never add descaling, aromatic, alcoholic or
detergent products to the water tank, as this could cause
damage to the iron or injury to the user.
Using the Two in One Cordless Iron
Using as a Cordless Iron
STEP 1: Check that the iron is switched off and unplugged from the mains power supply.
STEP 2: When the iron is on the iron stand, make sure that the heel of the iron is pushed
back and is secure.
STEP 3: Move the locking switch up to the cordless position. This will lock the power
unit to the iron stand and release the iron.
STEP 4: Plug in and switch on the iron at the mains power supply; the temperature light
will illuminate to signal that the iron is charging.
