Technical Manual
LioN-Link DeviceNet
Subject to change without notice!
Version 1.0 / June 2010
Page 20 of 27
6.5.1.
Parameter settings of the BusHead
The parameter settings of the BusHead are shown in the folder
Configuration Settings of the following dialogue box.
1.
Serial number
Each DeviceNet BusHead possesses a unique serial number. The serial number is 32 bits long and shown in the configuration
tool. The serial number can also be read by sending an Explicit Message to the BusHead. The message can be send through the
configuration tool in online mode or the PLC program.
Access is obtained using the class 01, instance 01 and the attribute 06.
2.
Software revision
The firmware version of the BusHead can be read out with the configuration tool.
Access is obtained using the class 102, instance 01 and the attribute 03.
3.
Count of modules line 1
This parameter shows the number of detected I/O-modules in the Lion-Link line 1.
Access is obtained using the class 102, instance 01 and the attribute 04.
4. Count of modules line 2
This parameter shows the number of detected modules in the LioN-Link line 2.
Access is obtained using the class 102, instance 01 and the attribute 05.
5. Collective Diagnostic Info
This parameter shows the detected I/O-modules with active diagnostics set. The collective diagnostics information is 16 bits
long, the single diagnostics bit corresponds to the module position starting with the first module in LioN-Link line 1.
Access is obtained using the class 102, instance 01 and the attribute 06.
