Belden Grass Valley MCP 450, User Manual

Page: 29 / 44

MCP 450 Master Control PC User’s Guide (v1.1) 29
Chapter 3 - Operation
3.4.3 Selecting cameras (in multi camera mode)
Click or tap anywhere in the lower right corner of the screen to open the camera selection
window. You can now select one or more cameras or a pre-defined group of cameras.
The upper half of the window shows the numbers of the cameras within the selected group.
The default group is the
All Available group that contains all available cameras in the system.
If you have defined your own groups they will be shown here. Learn more about managing
groups in
Section 3.5 on page 29 .
• Click or tap a camera group and it will be immediately selected and the camera selection
window closes, or:
• If a group was selected the camera selection window displays all cameras in that group.
You can make a new selection from the cameras. Click or tap
Ok to activate this selection.
• Click or tap All Available to show all cameras and make a selection by clicking or tapping
camera numbers. When your are done, click or tap Ok to activate the selection.
• Click or tap Cont Search to keep the list of cameras being updated. The list of cameras is
populated continuously.
3.5 Managing groups
To make studio control easy, especially with large numbers of cameras in a system, you can
define and maintain groups of cameras. Click or tap
Options in the camera selection window
to open the groups management window.
8 11 5 3 2 1
Group2 Group1 Cont. Search All available
Options Ok Cancel
Camera Select
Camera
matrix
Camera
groups
Open group maintenance
window