BEKOMAT 20, 20 FM
10
Electrical installation • Instalación eléctrica
Installation électrique • Instalação eléctricallatie
1
2
3
4
english
BEKOMAT 20
Note before wiring:
• Check type plate for permissible
mains voltage and ensure confor-
mity!
• The installation must be carried out
according to the valid regulations.
• Assign terminals as indicated!
• Electrical power must be discon-
nected prior to installation!
• Remove screws (
7
) and lift off front
cover (
18
)
• Unscrew cable fitting (
22-24
), remove
blanking plug and insert 3-core cable
for power supply (
31
).
• Join cable to terminal connector (
32
)
(The terminal connector can be pulled
off.)
• Plug terminal connector (
32
) onto PCB
(
20
).
Terminal assignment
L = phase conductor
N = neutral conductor
PE = protective conductor
• Put on power unit housing (
6
) and
tighten screws. Pull cable (
31
) tight
and firmly screw down cable fitting
(
22-24
).
• Replace housing top (
18
) and tighten
screws.
Mounting of front cover:
• Hook front cover into locking hooks at
the top. (
Fig. 1
)
• When lowering front cover, counterpres
-
sure of housing seal is clearly felt. (
Fig.
2
)
• Press front cover onto BEKOMAT hous
-
ing, insert and tighten screws. (
Fig.
3
)
Caution!
If the front cover is mounted according
to
Fig. 4
, correct positioning and sealing
(IP65) is
not
assured!
Summary of Contents for 20
Page 24: ...BEKOMAT 20 20 FM 24 ...
Page 25: ...BEKOMAT 20 20 FM 25 ...
Page 26: ...BEKOMAT 20 20 FM 26 ...
Page 27: ...BEKOMAT 20 20 FM 27 ...
