Beko WTE7604XLW0, Owner'S Manual

Page: 14 / 56

14 / English Front-Loading Automatic Washer
Installation Instructions
Power supply and circuit
Connect the clothes washer to the junction box supplied. Junction box must be connected to an
earthed outlet protected by a fuse of suitable capacity.
Important:
• Mains connection should comply with national regulations.
• The voltage and maximum total current are specified in the section “Specifications”.
• The appliance must not be directly connected to the mains in case of absence of junction box.
• Connection via extension cords or multi-plugs should not be made.
B
WARNING
¾ A damaged power cable must be replaced by a qualified electrician.
¾ The appliance must not be operated unless it is repaired! There is the risk of
electric shock!
15 Amp. Fuse or circuit breaker, 208-240 volt, 60 Hz, grounded, alternating current
Properly grounded 3-prong receptacle and junction box to be located so the power supply cords are
accessible when the washer is in installed position.
Water Supply Connection
Your washer comes with both cold and hot water connections. Connect the blue marked cold water
supply hose to the cold water inlet valve/faucet and the red marked hot water intake hose to the hot
water inlet valve/faucet. Screw the connecting bolts by hand and tighten the connection properly using
a plier. Over tightening may cause damage on bolted connection.
B
WARNING
¾ Be sure that the water connection of this washer is handled by a qualified
service technician or a plumber.
The washer has two bolted ½’’ water supply hoses and ¾’’ female hose connections that can be
connected to ¾’’ hot and cold water faucets.